MS51115B
Inches |
mm |
Inches |
mm |
.020 |
0.51 |
.81 |
20.6 |
.030 |
0.77 |
.84 |
21.3 |
.20 |
5.0 |
1.03 |
26.2 |
.320 |
8.13 |
1.145 |
29.08 |
.340 |
8.64 |
1.554 |
39.22 |
.37 |
9.4 |
2.12 |
53.8 |
.48 |
12.2 |
2.120 |
53.85 |
.75 |
10.0 |
2.44 |
62.0 |
4.390 |
111.51 |
NOTES:
1. This oil filled coil is designed for use with an external ballast resistance in distributors conforming to referenced specification.
2. Manufacturer's design will be acceptable in place of washer NASM35333 if interchangeability and function are not affected.
3. Dimensions are in inches. Metric equivalents are given for information only. Unless otherwise specified, tolerances are ± .01 on 2 place decimals and ± .005 on 3 place decimals.
4. Threads shall be in accordance with screw thread standards ASME B1.1 or FED-STD-H28.
5. This standard takes precedence over documents referenced herein.
6. Referenced documents shall be of the issue in effect on date of invitation for bid.
7. Marking: terminal polarity shall be clearly and permanently identified adjacent to the terminal. The
MS Part or Identifying Number (PIN) shall be applied to the part in accordance with MIL-STD-130.
8. This standard is not intended to limit construction to features other than as shown hereon by dimensions, notations and referenced documents. Tower must be maintained within all specified limits, regardless of form.
FIGURE 1. Coil, ignition dimensions and configurations - Continued.
Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes.
Referenced documents. In addition to MIL-D-13791, this document references the following: ASME B1.1
FED-STD-H28
MIL-STD-130
NASM35333
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business