MIL-DTL-13791G
6.3.6 Solid waste. "Solid waste" means (a) any garbage, refuse, or sludge from a waste treatment
plant, water supply treatment plant, or air pollution control facility; and (b) other discarded material,
including solid, liquid, semisolid, or contained gaseous material resulting from industrial, commercial,
mining, and agricultural operations, and from community activities. It does not include solid or dissolved
material in domestic sewage, or solid or dissolved material in irrigation return flows or industrial
discharges which are point sources subject to permits under section 402 of the Clean Water Act, (33
U.S.C. 1342 et seq.) or source nuclear, or byproduct material as defined by the atomic Energy Act of
1954 (42 U.S.C. 2011 et seq.) (Source: Federal Acquisition Regulations, section 23.402).
6.4 High peak voltage test generator. Equipment to produce the high peak voltage necessary to
calculate electrical resistance, as specified in 4.10.15.1 may be of any design producing requiring
parameters. Information pertaining to approved equipment and test methods may be obtained from the
US Army Tank-Automotive Command, ATTN: AMSTA-GDS, Warren, Michigan 48397-5000.
6.5 Environmentally preferable material. Environmentally preferable materials should be used to the
maximum extent possible to meet the requirements of this specification. As of the dating of this
document, the U.S. Environmental Protection Agency (EPA) is focusing efforts on reducing 31 priority
chemicals. The list of chemicals and additional information is available on their website
https://www.epa.gov/osw/hazard/wastemin/priority.htm. Use of these materials should be minimized or
eliminated unless needed to meet the requirements specified herein (see Section 3).
6.6 Guidance on use of alternative parts with less hazardous or non-hazardous materials. This
specification provides for a number of alternative plating materials via the PIN. Users should select the
PIN with the least hazardous material that meets the form, fit, and function requirements of their
application.
6.7 Subject term (key word) listing:
Direct current
Electrical components
Mounting
Rotor shaft
Shock resistance
Vehicles
6.8 Changes from previous issue. Marginal notations are not used in this revision to identify
changes with respect to the previous issue due to the extent of the changes.
CONCLUDING MATERIAL
Custodians:
Preparing activity:
Army - AT
DLA - CC
Navy - SH
DLA - CC
(Project 2920-2008-002)
Review activities:
Army - CR, CR4
Navy - MC
NOTE: The activities listed above were interested in this document as of the date of this document.
Since organizations and responsibilities can change, you should verify the currency of the information
above using the ASSIST Online database at https://assist.daps.dla.mil.
18
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business