MIL-PRF-62122E
AMERICAN NATIONAL STANDARD INSTITUTE (ANSI)
ANSI/ASQC Z1.4
-
Sampling Procedures and Tables for Inspection by
Attributes
ANSI/NCSL Z540-1
-
General Requirements for Calibration Laboratories
and Measuring and Test Equipment
(Copies of these documents are available from www.ansi.org or ANSI Customer Service
Department, 25 W. 43rd Street, 4th Floor, New York, NY 10036.)
AMERICAN SOCIETY OF MECHANICAL ENGINEERS (ASME)
ASME Y14.5
-
Dimensioning and Tolerancing
(Copies of these documents are available from www.asme.org or the American Society of
Mechanical Engineers, 22 law Drive, P.O. Box 2900, Fairfield, NJ 07007-2900.)
ASTM INTERNATIONAL
ASTM G21
-
Standard Practice for Determining Resistance of Synthetic
Polymeric Materials to Fungi
Rubber Property Durometer Hardness
ASTM D2240
-
(Copies of these documents are available from www.astm.org or ASTM International,
P.O. Box C700, West Conshohocken, PA 19428-2959.)
SAE INTERNATIONAL
SAE AS478
-
Identification Marking Methods
(Copies of these documents are available from www.sae.org or SAE Customer Service, 400
Commonwealth Drive, Warrendale, PA 15096-0001.)
2.4 Order of precedence. In the event of a conflict between the text of this document and
the references cited herein, the text of this document takes precedence. Nothing in this
document, however, supersedes applicable laws and regulations unless a specific exemption has
been obtained.
3. REQUIREMENTS
3.1 First article. Unless otherwise specified (see 6.2), the contractor shall furnish
samples of the cable assemblies, plugs, receptacles and adapters which shall be subjected to first
article inspection (see 4.3). First article inspection samples, properly marked with identifying
information shall be representative of the cable assemblies to be furnished to the Government.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business